UN R46 change reports — Devices for indirect vision
UN Regulation No. 46 (ECE R46) — Uniform provisions concerning the approval of devices for indirect vision and of motor vehicles with regard to the installation of these devices.
07 series
- 07 series — Supplement 2
Camera and monitor parts outside the vehicle are now exempt from the relevant provisions if their material has a Shore A hardness below 60.
- 07 series — Supplement 1
This Regulation does not apply to vehicles of category Y or to vehicles of category X without a manual mode operated on-board the vehicle.
- 07 series — Base text
New paragraphs 16.3. to 16.3.4. give installation requirements for surveillance camera-monitor-recording devices.
06 series
- 06 series — Supplement 2
Camera and monitor parts outside the vehicle are now exempt from the relevant provisions if their material has a Shore A hardness below 60.
- 06 series — Supplement 1
Paragraph 16.1.1.4. does not apply to some vehicles that have an ADR de-energization feature (new paragraph 16.1.1.4.1.).
- 06 series — Base text
New paragraphs 12.7. to 12.9. define centre-steered and side-steered vehicles; separate provisions give each a Class VI field of vision and CMS magnification factors.
05 series
- 05 series — Supplement 2
Camera and monitor parts outside the vehicle are now exempt from the relevant provisions if their material has a Shore A hardness below 60.
- 05 series — Supplement 1
New paragraphs 12.7. to 12.9. define centre-steered and side-steered vehicles; separate provisions give each a Class VI field of vision and CMS magnification factors.
- 05 series — Base text
New paragraph 6.2.2.1.2. exempts parts of the CMS external surface that protrude less than 5 mm from the radius requirement, under conditions on their angles.
04 series
- 04 series — Supplement 10
Paragraph 6.1.1.3. does not apply to mirrors with the lower edge mounted not less than 2 m above the ground (new para. 6.1.1.9.). Paragraph 6.2.2.1.1. does not apply to CMS with the lower edge mounted not less than 2 m above the ground (new para. 6.2.2.1.6.). The height applies with the vehicle loaded to its maximum technical permissible mass.
- 04 series — Supplement 9
The reflecting surface of a mirror must now be flat or convex, instead of flat or spherically convex (para. 6.1.2.2.1.).
- 04 series — Supplement 8
When a combined continuous image is allowed, any changes in magnification may now be indicated to the driver using indication lines.
- 04 series — Supplement 7
To enable an improved view in special manoeuvres, new paragraph 16.1.1.1.1. permits a temporary change of the field of view, under conditions.
- 04 series — Supplement 6
Within the minimum required field of vision (para. 16.1.1.3.), overlays must now display only safety-related rearward vision information, instead of rearward driving-related visual information.